Page 1 of 1

B16 o K20a3????

PostPosted: Sun May 27, 2012 6:50 pm
by mannyeg6
hi guys im posting this because I can't seem to make up my mind about this swap. I got a b16 and a k20a3 but it's just too hard to decide. Help!

PostPosted: Sun May 27, 2012 7:18 pm
by bradleyg
Any reason why you have it down to those two? A K-swap will cost you alot more.

PostPosted: Sun May 27, 2012 8:52 pm
by mannyeg6
i got a good deal for this two motors but i dont know wich one of this two to keep....

PostPosted: Sun May 27, 2012 9:50 pm
by TrailerTrash
Well you could do either one... and u could sell the one you dont use to fund the swapping of the other.

do you just have the motors and nothing else for the swaps?

PostPosted: Sun May 27, 2012 10:25 pm
by poorman type-r
Unless you have a fat stack of cash to spend swapping in a K, I would do the b16 and sell the K. So many people buy K-swaps and try to save up for the parts to install it, after a while they find out just how expensive all of those parts are and they give up on it. It's up to you though.

PostPosted: Sun May 27, 2012 11:12 pm
by mannyeg6
Thank you guys for your opinion...I just don't have the money to do the k swap I'm gonna sell it and back to the b

PostPosted: Mon May 28, 2012 8:25 pm
by poorman type-r
If you sell it, buy a b20 block and slap the b16 head on it. You will have around the same if not a bit higher numbers than the k20a3. :thumb:

PostPosted: Sat Jun 09, 2012 7:55 pm
by mannyeg6
:thumb: :thumb: :thumb: :thumb: :thumb: :thumb: :thumb: