Civic EG

Hey guys this is my first ever swap and was wondering if I could get some conformation on some wiring questions. I have a 95 civic dx hatch that I put in a 95 integra gsr with a JDM b18c all stock, and with all the searching that I have been doing things are starting to get confusing. I belive that I need to wire up the vtec solenoid, vtec pressure, knock sensor and a few guys said something about IAB. I need to finish this up sooner than later with the winter comming up. If you need any other info let me know and ill get right back. Thanks guys.

i dont think you would need to wire for knock sensor, but vtec solenoid, vtec pressure,


you can purchase conversion harness from rywire for those items to make it easier for you.

Perfect thanks

so you are putting a vtec motor in a non vtec car??

the wiring is easy all you have to do is add some wires from the motor to the ecu thats all nothing special
http://www.ff-squad.com/tech/wiring/wiring.92-95.jpg
http://www.ff-squad.com/tech/wiring/obd1.shocktowerplug.jpg
http://www.ff-squad.com/tech/wiring/obd1.pin_removal.jpg
the last two is if you want to run the wires to the factory shock tower plugs and who to depin them