how to remove

Springs, Struts, Swaybars, Bushings, Tower Braces & more
 Reply
User avatar

how to remove

By ikon
- Wed Dec 16, 2009 4:38 am #162162 how do i get this

Image

off of this

Image
User avatar

By asianrob
- Wed Dec 16, 2009 4:48 am #162168 take off the axlenut, axle (does not need to be take out from the trans but from the hub), upper A-Arm, lower control arm, take off brake caliper.


assuming it you are going to replace those studs take it to get it pressed out any place that has a press can do it.
User avatar

By Dippin_EG
- Wed Dec 16, 2009 4:56 am #162171 indeed you wll need a press. and you also will need to take off the nut for the tie rod and bang it out... i hate balljoints :lol:

And props on the idiotproof question. :thumb:
User avatar

By ikon
- Wed Dec 16, 2009 5:00 am #162172 yeah man who needs paint shop :lol: i was hopin i didnt need a press but oh well. ill just replace all the studs and do it right. so is that the only way to replace the wheel studs besides grinding them down?
User avatar

By asianrob
- Wed Dec 16, 2009 5:03 am #162174 its the only way lol... might as well go ahead and buy a new wheel bearing and ball joint if bad. get them all replaced at the same time! or go to the junker and get another spindle
User avatar

By sneepereg
- Wed Dec 16, 2009 5:34 am #162178 make sure to post picks ill be doing this soon hopfully
 Reply
Return to EG Chassis Suspension