Civic EG

Posted: **Tue Sep 13, 2011 3:40 am**

My CX has no mounts for a front sway bar. Which OE lower control arms can I use? 92-95 Civic or 94-01 Integra? Or can I use both? Its just a bummer cause I spent two weekends pressing in all the poly bushings! O well. Any advice?

Posted: **Tue Sep 13, 2011 3:57 am**

either will work. DC2 or EG.

Posted: **Wed Sep 14, 2011 10:00 am**

Even DA front control arms should be the same as the EG and DC2.

Posted: **Wed Sep 14, 2011 6:39 pm**

EJ1_MK wrote:Even DA front control arms should be the same as the EG and DC2.

edit: misread post. Front lowers are not compatible, however the rear lowers are :wink:

Posted: **Wed Sep 14, 2011 8:46 pm**

http://www.am-autoparts.com/1992/Honda/ ... 51502.html

Posted: **Thu Sep 15, 2011 5:43 pm**

RWMIII wrote:
EJ1_MK wrote:Even DA front control arms should be the same as the EG and DC2.

x2

They're not even similar.

DA

EG/DC (EK are simliar, not sure if compatible)

[/img]

Posted: **Thu Sep 15, 2011 10:49 pm**

Good for you :thumb:

I misread the post. The rears are compatible, not the fronts.

Posted: **Fri Sep 16, 2011 4:09 am**

civic LX, EX, Si 92-95 or any 94+ integra's will work.

Posted: **Fri Sep 16, 2011 9:11 am**

My bad I forgot DA run a torsion bar up front. But EK should be the same as EG/DC, tend not to see that many DA running around anymore.

Posted: **Fri Sep 16, 2011 3:37 pm**

OleFolk wrote:http://www.am-autoparts.com/1992/Honda/Civic/ControlArmsFront/AM-30497104/351502.html

Its right here
Just get these

Civic EG

Need to know which Front Lower Control Arms to get?

Need to know which Front Lower Control Arms to get?