Civic EG

im looking into taking off my door trims along the doors , i was wonder has any1 done it before and are they clipped it stuck onto the car , and how easy is it to removing them ??

the have a plastic clip on the backside of them and on the very ends i think they have screws, there kinda a bitch to get off, and there will be holes there when you remove them...

i was going to fill the holes over so it would look like this 1

i cant see ur pic so are you going to fill the groove in and completly shave it of just weld the holes shut and keep the factory outline like a cx or vx has? my boosted cars has them completely shaved, (it was like that when i got it) personanaly i wouldnt recomend doing it like that unless you weld metal in and make it flush with metal and use a skim coat of filler, if you just fill it in with fiber glass (like the boy did mine) it will just crack out...

im going to weld the holes shut and keep the factory outline

it will take time but itll be worth it

i just want to make my civic that bit diffrent but im keeping the door handles and mirrors black

well, it wont be that different since a few of the hatch models come from the factory without moldings or holes, just the outline..

im going to fix where my boosted car is cracking out and get the jdm thin side moldings

there's none done like it in the UK , most of them are smoothed over

personally i like the cx/vx look, its the cleanest look imo, i personally dont want to take the time to fill them in on mine because of how it was allready done...

yer ,i like that ,im knee on the smoothed look,im gonna keep the factory outline look on them

hell yea it should look good