Civic EG

ok i just got a pair of ek sideskirts i went to test fit them, and towards the back wheel sticks out ....

the only thing that looks like its keeping it from going all the way in is the little bur/lip on the top of the skirts .....it seems like if i sand that down flat they will go right in.....

if i put them up to the side as far as they go i can stick my finger in through the back and feel like two fingers width in btw the clip and the body.

and the front is fine it fits perfect


did anybody else have to do this?

sry if it confusing

You will have to cut the side skirt to the right length and drill holes for it to mount to the car. The stock EG holes will not line up.

or put new holes in the rocker of your car. Measure, drill, and file them into a square. Blake's method sounds a lot easier!

no i got the holes fine it the lip at the top of the sideskirts..it kinda like a little burr......that part is hitting my car


<<<<that burr


lol this might help

and the arrow is not pointing to th edge of the sideskirt i kno not to sand that there's a burr/lip kinda that goes underneath the hangover of your quarter.

i was wondering if anybody had to sand this off to get it to fit under the rear quarter where it clips in ... the clips and holes are fine just the back top part of the sideskirts are doing this


and they stick out towards me when im trying to put them on they dont stick out towards the back tire or down or anything like that just out away from the body..... everything lines up perfect in that matter

nvm the skirts i got from b18ctrb matched perfectly with out that stupid lip on it


thanks anyways guys