Page 1 of 1
Swapping seats in a hatch

Posted:
Fri May 13, 2011 1:17 am
by ghskid06
What seats (front and back) are known to fit into a hatch with nothing more than minor modification? After a strong list is compiled i feel a sticky should be made since swapping is so common.

Posted:
Fri May 13, 2011 2:47 am
by forcefedEG
Integra seats are the moat common closest to direct fit seats to swap to a hatch, as long as there from a 2 Dr


Posted:
Fri May 13, 2011 2:33 pm
by poorman type-r
RSX Type s seats fit nicely, and look nice if you like the black leather look.

Posted:
Fri May 13, 2011 7:42 pm
by ghskid06
This the only two that fit without much mods?
Prelude rear seats fit?
accord seats fit?
I know integra seats fit but arent there certain years/peices that need mixe matched in some cases?

Posted:
Fri May 13, 2011 11:07 pm
by Vti93T
your best bet is going to be the integra front and rear seats..if you just want the fronts then Del Sols are nice (sit low) and prelude seats fit but they (in my opinion) stick up way too high.

Posted:
Sun May 29, 2011 2:07 pm
by andyc
I loooove my lude seats


Posted:
Mon May 30, 2011 2:53 am
by pcbabb
if you go with teg rear seats then you will need a bottom from a 4dr. The 2dr bottom is too small.

Posted:
Mon May 30, 2011 3:46 am
by Rufuseg8
Cant be too detailed since I own a sedan but-
94-01 Integras Fronts always fit. Not sure about 93 down
94-01 Rears fit but sedan bottom is preferred because there wont be a gap.

Posted:
Mon May 30, 2011 5:28 am
by kapow
I know from experience, seats from a EG sedan are 1inch higher then hatch back seats. It's not the seats themselves but the rails.

Posted:
Wed Jun 01, 2011 6:45 am
by dbrooks
if you want integra seats, don't get DA seats. they will not fit. be sure to get seats from a DC.
and someone said something about RSX seats. those will make you sit up high. i'm 6 foot and there's no way i could rock them. plus, i don't think they're straight bolt in

Posted:
Wed Jun 01, 2011 10:00 am
by gtstripes
what would i need to do to install del sol seats in my sedan??

Posted:
Wed Jun 01, 2011 1:43 pm
by ghskid06
gtstripes wrote:what would i need to do to install del sol seats in my sedan??
Good question. I know they are too narrow I believe you need to extend the brackets.
Hopefully someone will sà y for sure though.

Posted:
Wed Jun 01, 2011 3:38 pm
by ImThaBean
Swap the bolted rail from the EG and Delsol. they drop in after that. DelSol seats are NOT direct drop ins but swapping a rail is easier than you think.

Posted:
Wed Jun 01, 2011 9:56 pm
by Greasedmonkey
The del sol and teg front seats are the easiet to put in, being that they are bolt in. I have a set in each hatch. I also have 2dr teg rear seats in both hatches as well. They are indeed shorter than the civic seats, but still fit just fine. you will have a small gap on each end, other than that its all good.
Here are some pics of how mine are.


Posted:
Mon Jun 06, 2011 4:34 am
by asianrob
on the del sol seats. switch your seat rails from your car to those seats. and they will bolt in.
all integra front seats will bolt in (94-01)