Civic EG

Posted: **Thu Jan 20, 2011 2:00 am**

ok my car isnt a eg i have a 96 sedan but this is only place i can think about asking ok when i bought my car the guuy before me molded the bumpers to the car now my question is how hard is it to remove the bumper and put it back to stock nothen molded???

Posted: **Thu Jan 20, 2011 2:16 am**

its not so hard just bring the stock bumber there is
2 - 10 mm at the end of the bumber just take them out
then open your hood there will be 5 or 6 10 -mm take them to
and instsll the new one its easy
i hope i helped you

Posted: **Thu Jan 20, 2011 3:45 am**

It depends on how good of a job the previous owner did. Was it fiberglassed? Could you post some pictures?

Posted: **Thu Jan 20, 2011 3:07 pm**

srry its back bumper but its molded like there is no seems between the bumper and the quarter panel is all molded smooth