Civic-EG.com Forum 3.3.1

- Mon Jul 19, 2010 2:29 am #205260 So im not sure if everyone has this but i have 4 holes in my front bumper for the license plate, and if anyone else have and covered them to make the bumper smooth or what ever was done how did you get the threaded things out, because im not even using it for my license plate and there rather annoying and noticeable and if i can find out how to get the threaded things out ill try and melt the little bump and fill in the holes and make it smooth etc, sorry for sounding odd i dont know how to ask what im asking ill post a pic tomorrow.

- Mon Jul 19, 2010 3:10 am #205267 I bought a little repair kit from O'reilly and it worked really well. Just grind down the threaded parts, sand down the area lower, put the patch over the whole and spread the epoxy around. After that I sprayed it over with filler primer.

- Mon Jul 19, 2010 3:10 am #205268 Yes, that is the placement for the license plate. And there is a plastic cap from the dealer which you can purchase. But it won't be smooth as the cap will raise it a little once capped off.

- Mon Jul 19, 2010 3:37 am #205271 scotch brite pad on a pneumatic drill took care of it. filled with bondo

haven't gone through a winter with it yet tho..

[teal_dx]

- Mon Jul 19, 2010 1:44 pm #205319 I used the bondo with the fiberglass strands in it. It's been a few years and no cracks yet!

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Mon Jul 19, 2010 4:57 pm #205339 I melted plastic into it. Kind of like plastic welding

My build Thread
http://civic-eg.com/viewtopic.php?t=14912

- Mon Jul 19, 2010 6:47 pm #205353 just buy the oem block offs they pop right in and they come in you oem color



^^^^not trying to post whore

#1 Member of CHANCE is HOMO club:thumb:

1994 civic dx hatch-sold
1992 civic dx sedan-sold
2001 ap1 s2000 -daily

- Mon Jul 19, 2010 6:48 pm #205354

just buy the oem block offs they pop right in and they come in you oem color



^^^^not trying to post whore

Thats true too
Postwhore

My build Thread
http://civic-eg.com/viewtopic.php?t=14912

- Wed Jul 21, 2010 10:57 pm #205681

I melted plastic into it. Kind of like plastic welding

Lmao the shop we work at we call them welds but yeah ill try and use the grinder to get down the threads and weld the holes shut and if theres spaces ill use fiber glass, and i hope you people who use fiberglass and bondo have fiberglass base then bondo and glaze on top of that then use a high build surface primer or w.e xD