Civic EG

So i picked up a carbon fiber hood the other day and imo no washer jets is pretty dangerous.I know the integra has them built onto the wiper cowl.But the integra cowls dont fit out cars!

I want to know peoples thought on this.I was planning on centering up my cowl and drill holes into it and installing the washer jets just like integras.But i have no idea if it will work or not.Has this topic been discussed before.My car(when finished) will be my daily driver and function IS nesseccary. Forgive my spelling please and thank you in advance!

great idea! I don't see why it wouldn't work. you'll just have to run longer fluid lines and re-route them.

Great idea!!!!
DIY it please if you will go through with it!!!

i did something similar to how GM had theirs on their trucks.

get the washer squirters from their trucks (they are clipped on) get some washer tubing and connect them to each and find a spot for them to clip on and then cut the hose to length.

This is a good idea man, I hope you do this id love to see the results
Maybe another idea, Is tilt the cf Hood and somehow place jets within space between hood and cowl..

Next time you are around your buddies integra.Who ever you may be look at where the jets are. I am going for this it may be a few days down the road but i will make a diy There is already two holes drilled through for hood pins So another 2 i can't handle lol.

I have the jets out my old rusted hood.Anyone who wants this diy to take off i am requesting a pic of an integra cowl.So i can get a general idea or where to put them