Civic EG

Posted: **Wed Sep 26, 2012 3:43 pm**

hey guys i just picked up a new used fender that was in good condition and already had same color paint. But now i just noticed the side molding holes are not there so what is the best way to go about this to get the little 2 hole side molding piece on. I am just thinking measure old fender and just drill a hole about the size of the clip and hope it comes out lined up.

Posted: **Wed Sep 26, 2012 4:16 pm**

Yeah drill a hole and then make the corners square with a tiny file. Or replace all your side mouldings with the thin JDM ones that go on with 3m tape (no clips).

Posted: **Wed Sep 26, 2012 5:56 pm**

dang nice i didnt think of the ole file trick. Well trying this today hope for the best lol.

Posted: **Wed Sep 26, 2012 6:05 pm**

be sure to clean/primer/paint the holes so they don't rust :thumb:

Posted: **Wed Sep 26, 2012 7:26 pm**

Ok i am just going to spray some rust preventive stuff there if it get on paint it just go clear and turns black on rust i will paint the whole car in about a month and get the jdm slim ones

Posted: **Wed Sep 26, 2012 7:53 pm**

OR BETTER I GUESS I WILL TAPE IT OFF AND RATTLE PRIMER AND RATTLE PAINT THE HOLES SINCE THEY WONT SHOW COLOR WONT MATTER