Page 1 of 1
12.5 d16z6 build question
Posted:
Fri Apr 23, 2010 1:38 amby j0keefe21
ok so basically i got a d16z6 with the ls rods and gx pistons. it has full bolts ons and a port matched head... what i was wondering is if i should invest the money into a cam for this setup? i have read conflicting threads about if its worth it or not.i was just wondering with my high of compression would i see noticeable gains with say a zex 59300... also this set up will be seing nitrous at somepoint thanks
Posted:
Fri Apr 23, 2010 5:50 amby 93hatcheg
imo opinion thats a no brainer! buy the cam i feel that for a build that nice a cam should have been sought after before the ls rods. thats my 2cents
Posted:
Fri Apr 23, 2010 12:50 pmby forcefedEG
with what you have done you wouldnt be wasting your money imo...
Posted:
Sat Apr 24, 2010 1:11 amby j0keefe21
yea i was just trying to build a solid block and build the head after... now should i go with something like the crower stage 2 with the higher lift or the zex thats has more duration on the exhaust side for my nitrous?
Posted:
Tue Apr 27, 2010 1:17 amby MI_excoupe
I would think that the Zex would be better for a nitrous setup. Just for the simple fact that it's made by a company known for nitrous so they might build the cam specifically for motors with nitrous. I don't know for sure though, I've never had to do anything with nitrous at all yet.
Posted:
Tue Apr 27, 2010 5:17 pmby Greasedmonkey
you will a pretty big cam to make use of that cr. i dont think stage two cams will be enough.