Bitch pin
Posted: Sun Apr 11, 2010 7:32 pmDo I take it out from the top down or the bottom up I can't het this thing out
Page 1 of 2
Posted: Sun Apr 11, 2010 7:32 pmPosted: Sun Apr 11, 2010 9:01 pmfrom the bottom up and its hard so spray lube and pray
Posted: Sun Apr 11, 2010 9:04 pmWhat r u using anyways??? The right way is to use a punch pin...
Posted: Sun Apr 11, 2010 10:39 pmI was using some screw driver bits no success if I buy a 8mm punch will it come out?
Posted: Sun Apr 11, 2010 10:40 pmN e 1 ever leave it on? I'm just dropping the motor out the bottom
Posted: Sun Apr 11, 2010 11:13 pmno leaving it in wont work. take a 1/4 deep socket and 3inch extension and hiit it with a hammer. should pop right out.
Posted: Sun Apr 11, 2010 11:26 pmdnt stop tryin. try somethin new and if it dont work try it again. hence the bitch pen. get the punch set. it was like 6 bucks from home depot.
Posted: Mon Apr 12, 2010 12:58 amGet under the car, take a 6mm punch and a hammer and knock the pin up and it will come out.
Its not as hard as the name implys.
Reference Topics:
http://civic-eg.com/viewtopic.php?t=128 ... =bitch+pin
http://civic-eg.com/viewtopic.php?t=116 ... =bitch+pin
Its not as hard as the name implys.
Reference Topics:
http://civic-eg.com/viewtopic.php?t=128 ... =bitch+pin
http://civic-eg.com/viewtopic.php?t=116 ... =bitch+pin
Posted: Mon Apr 12, 2010 1:05 am6mm or 8mm?
Posted: Mon Apr 12, 2010 4:12 amwow, i was just wrestiling with one of these with my engine swap today!
i ended up leaving it on the old engine and pulled it out with it still attached!
THEY ARE A BITCH!
i ended up leaving it on the old engine and pulled it out with it still attached!
THEY ARE A BITCH!
Posted: Mon Apr 12, 2010 6:12 amHa I want to leave it on too but I'm dropping the motor out the bottom
Posted: Mon Apr 12, 2010 6:23 amPosted: Mon Apr 12, 2010 12:23 pmive never had a problem using a flat punch.... 
Posted: Mon Apr 12, 2010 1:08 pmyeah thats what i did, removed it form the bottom.
and pulled the engine straight foward out with the linkage still attached.
and pulled the engine straight foward out with the linkage still attached.
Posted: Tue Apr 13, 2010 12:44 amRemoving the "bitch pin" Without using a hammer
wtf where was this when i needed it