Civic EG

I'm pretty sure I know the answer to this but I have my doubts. I want to have a gsr cluster in my hatch. I saw both versions in the d.I.y section. But how about the wiring? How different is it? Thats my weakest link. And thats what's holding me back on doing this [/code]

I also did the swap, following one of the DIYs here. This is the guide that I used to re-wire the harness: http://honda-tech.com/showthread.php?t=1053318

It is pretty easy, and not that difficult once you know your way around with a soldering-iron. It is different, every wire should be soldered to another one on the GSR harness wires. Nothing scary, just takes some time.

so if i go to the junkyard i gotta get the cluster, and cut the connections too?

Adrian91 wrote:so if i go to the junkyard i gotta get the cluster, and cut the connections too?

yes you need the cluster plugs too

Adrian91 wrote:so if i go to the junkyard i gotta get the cluster, and cut the connections too?

Yeap, cluster and pigtails.
Follow the write up said above and it should be cake

Also, if in some weird case, the cluster has no plugs/connectors, I am told that the ones from EK are also a match.

Good luck!

i read it all over, and looked at the wiring charts. the wiring is still getting me confused. i dont get what wires i gotta put where. Ugh... anyone like in chicago who can do it for me if i pay u?

Ship me your integra pigtails and ill hook you up
Ill make you a plug and play thing for you.

chilango41 wrote:Ship me your integra pigtails and ill hook you up
Ill make you a plug and play thing for you.

pm sent

Does the EK and the EG hatches have the same cluster connections in the back?

Adrian91 wrote:Does the EK and the EG hatches have the same cluster connections in the back?

Nope.