Civic EG

I have a 97 prelude I'm parting out but I have good seats in it and I wanna putting them in my 93 EG. Anyone know how I am supposed to go about this? Do I just change the rails? Or drill out the rivets that hold the bolt holes? And swap them? What would be the best way to go about it.

Thanks guys.

might be able to swap the rails. i would try that first

if not you might have to mod it like the crx si seats

asianrob wrote:might be able to swap the rails. i would try that first

if not you might have to mod it like the crx si seats

Thanks I'll try the rails tomorrow. I'll let u know how it goes.

sounds good. i hope its just as easy as that lol

I just bolted 2 bolts n it holds.

blk97supra wrote:I just bolted 2 bolts n it holds.

Bad idea... if someone rear-ends your car, you're going to wish you used all 4 rail bolts instead of only 2.
Think about your safety

x2

x3
for the bolts that don't line up just make custom brackets from your rails to the mounting holes probably going to need to weld it. You don't want to go flying out your car if you get in an accident

Well its one rear bolt and one front bolt opposite of each other. But might make a custom bracket for the other rear mount hole like Guy23 said cause 3 bolts be better then 2 till I get the racing seats.