Page 1 of 1

FS: EG pillar pod, misc Dseries engine parts

PostPosted: Sat Sep 17, 2011 9:36 pm
by Zen Chameleon
I don't need any of this so my loss is your gain. everything OBO!!!

So lets get started---->>>

Glowshift 92-95 hatch dual gauge pillar pod= $40 shipped

Image

LS rods = $35 shipped

Image

2 sets of stock head bolts: left set is for D16Y7, right set is for D16Z6.
$10 shipped each set...need some mixed and matched for a mini-me? sure why not

Image

EG drivers side engine mount= $15 shipped

Image

Rear T bracket mount, D16 96-00= $30 shipped

Image

PostPosted: Sat Sep 17, 2011 9:37 pm
by Zen Chameleon
3" Vstack= $25 shipped

Image

D16y7 flywheel = $35 shipped

Image

D-series Alt, tested good = $35 shipped

Image

ECU bracket = $10 shipped

Image

Stock D16Z6 springs and retainers = $30 shipped

Image
These were cleaned up at Performance Porting when he did my head work. complete set. Sorry, my battery was dying on my camera but can get better pics on request.


Just for you Cali folk. D16Z6 exhaust mani with the stupid O2 sensor that I can't get off = $35 shipped

Image

PostPosted: Sat Sep 17, 2011 9:43 pm
by Gustavo
If only that pod was a 3 gauge.

PostPosted: Sun Sep 18, 2011 10:12 pm
by Zen Chameleon
Gustavo wrote:If only that pod was a 3 gauge.


If only it would fit my Sol so I didn't have to try and sell it lol

PostPosted: Mon Oct 03, 2011 4:44 pm
by Chambers
Is the pillar gauge pod grey or black?

PostPosted: Sun Oct 09, 2011 8:57 pm
by Zen Chameleon
Chambers wrote:Is the pillar gauge pod grey or black?


Sorry for the late reply, I thought I had this thread set-up to notify via email.

It's black