code 43
Posted: Tue Jan 12, 2010 10:15 pmi know this is a fuel systems code....what all do i need to check? i replaced the fuel filter....was else would i need to check fuel pump?
Page 1 of 1
Posted: Tue Jan 12, 2010 10:15 pmPosted: Tue Jan 12, 2010 10:21 pmis your car running or no. if it wont start i would say pump or relay.
Posted: Tue Jan 12, 2010 10:55 pmit barely wants to start...like i cranks up the cuts right off and after few times of this if i can catch the gas pedal at the right time it will stay running....but runs ruff....i also got a code 4 which is crank shaft position sensor...
Posted: Wed Jan 13, 2010 12:45 amcrank shaft position sensor is in the Distributor.
See if you can borrow a distributor from a friend and try it on your engine.
Remember to unhook the battery for 10-15 mins to clear the codes. Or there's the ECU fuse you can pull, but I forget which one/color it is. I think it's red 10A in the underhood fuse box
See if you can borrow a distributor from a friend and try it on your engine.
Remember to unhook the battery for 10-15 mins to clear the codes. Or there's the ECU fuse you can pull, but I forget which one/color it is. I think it's red 10A in the underhood fuse box
Posted: Wed Jan 13, 2010 2:10 amteal_dx wrote: I think it's red 10A in the underhood fuse box
7.5 "back up light" under the hood
that way you dont have to wait ten or fifteen to drive your car
Posted: Wed Jan 13, 2010 1:04 pmok will do...and hell ion have nothing but time so waiting cant hurt me to much lol.....one question where is the fuse for the fuel pump at under hood or dash..and wat color and amps?
Posted: Wed Jan 13, 2010 3:12 pmJust disconnect the ecu just take the 3 pugs out and put them back in it will re set the ecu I went thure 6 fucking tempeture sensers I kept pulling out the fuse and that shit never re set I disconnected the ecu and bam no more code 6