d16a6/d16z6 minime oil use after new rings

D15, D16, D17 and Mini-Me swaps
 Reply
User avatar

d16a6/d16z6 minime oil use after new rings

By 92civic_vx
- Sun Apr 03, 2011 3:09 am #247948 i just finished putting new rings in my minime A6/Z6. after setting the rings (in 3rd gear upto 50 down to 30) did that 10-12 times as haynes manual states, how much oil use is normal? haynes states "some" oil use during the first break in is normal. just curious if anyone has some input on how much oil it should use. i drove it 3 to 3 1/2 miles doing the break in and used 2 qts of oil already, is this "normal"? :?
User avatar

By forcefedEG
- Sun Apr 03, 2011 3:32 am #247955 I would say no, did you make sure you put the rings on the piston facing upwards in the right direction did you hone your cylinder walls? Jw.
User avatar

By 92civic_vx
- Sun Apr 03, 2011 3:58 am #247959 yes all rings were installed correctly. yes used a ball hone. haynes had a note stating it will use oil during the break in period. i didnt notice any smoke or any leaks. it was also 1030 and didnt have great light. i am going to check it out in the morning look for any leaks and get someone to folllow me to look for smoking.
User avatar

By forcefedEG
- Sun Apr 03, 2011 4:02 am #247962 Yea, if it was dark it would be hard to tell. Def. Make sure your pcv valve is good too. :thumb:
User avatar

By 92civic_vx
- Wed Apr 06, 2011 3:27 am #248616 found no leaks and she not smoking :woot: drove it 85 miles on sunday, ran great but CEL came on while i was on the highway. when i got to my sisters house went out to check the code but cel was off and got nothing lol. then this morning on my way to work my ac tensioner pully passed me on the street :thumbdown: any1 know what thread size nut i need to replace it?
User avatar

By forcefedEG
- Wed Apr 06, 2011 4:00 am #248623
JUICE wrote:so it's not losing the oil anymore??



Wondering the same thing :?
User avatar

By 92civic_vx
- Wed Apr 06, 2011 4:29 am #248629 no, it burnt it up setting the rings i guess :? anyone know what size nut i need for the ac tension pully? i lost it and the bearing cover. :thumbdown:
User avatar

By d-mon
- Wed Apr 06, 2011 2:28 pm #248680
92civiclx wrote:no, it burnt it up setting the rings i guess :? anyone know what size nut i need for the ac tension pully? i lost it and the bearing cover. :thumbdown:

you have to tighten it down after adjusting the tensioner.
IIRC 14mm.
you can get another one at the junkyard.
 Reply
Return to D Series