Civic EG

Am looking to completely remove my clutch line including the hard line then replace it with a braided line but want the know how long I will need to make it to reach from the clutch master cylinder to the slave cylinder on the gearbox.

I do drive a RHD so I know the measurements will be shorter than that of a LHD I can check on my car as the motor isn't installed.

Thanks in advance

Well on my car LHD i have a russell stainless braided line. it was 70". and that's running it around the firewall. id say take out about 20-25" of line since your RHD.. it's more direct ..

Nice one thank you any idea what that might bE in cm or meters as that's what we work in over here lol