ek skirts on eg question with pix

Appearance, Paint & Body Work
 Reply
User avatar

ek skirts on eg question with pix

By hatchie
- Fri Mar 13, 2009 2:18 pm #102934 ok i just got a pair of ek sideskirts i went to test fit them, and towards the back wheel sticks out ....

the only thing that looks like its keeping it from going all the way in is the little bur/lip on the top of the skirts .....it seems like if i sand that down flat they will go right in.....

if i put them up to the side as far as they go i can stick my finger in through the back and feel like two fingers width in btw the clip and the body.

and the front is fine it fits perfect


did anybody else have to do this?

sry if it confusing
Last edited by hatchie on Fri Mar 13, 2009 5:59 pm, edited 1 time in total.
User avatar

By Greasedmonkey
- Fri Mar 13, 2009 4:39 pm #102960 You will have to cut the side skirt to the right length and drill holes for it to mount to the car. The stock EG holes will not line up.
User avatar

By hatchie
- Fri Mar 13, 2009 5:13 pm #102969 no i got the holes fine it the lip at the top of the sideskirts..it kinda like a little burr......that part is hitting my car


Image<<<<that burr :lol:


lol this might help

and the arrow is not pointing to th edge of the sideskirt i kno not to sand that there's a burr/lip kinda that goes underneath the hangover of your quarter.

i was wondering if anybody had to sand this off to get it to fit under the rear quarter where it clips in ... the clips and holes are fine just the back top part of the sideskirts are doing this


and they stick out towards me when im trying to put them on they dont stick out towards the back tire or down or anything like that just out away from the body..... everything lines up perfect in that matter
User avatar

By hatchie
- Fri Mar 13, 2009 9:10 pm #103024 nvm the skirts i got from b18ctrb matched perfectly with out that stupid lip on it


thanks anyways guys :woot: :woot: :woot: :woot:
 Reply
Return to Exterior & Body